V-belt Builder
Overall rating: (N/A)
|
Bulids up plies (layers) of rubber and filler to form V-belts:
Hoists rolls of calendered rubber for belt base and filler from
storage to worktable, using hoist. Sets drum to specified
circumference by turning wheel and verifies size with rule.
Pulls rubber from rolls and measures and cuts it with scissors.
Brsuhes rubber cement on sides of rubber, lays one or more plies
of rubber around drum, and splices ends. Threads end of cemented
belt cord from spool through lathe gudie and spots ends at edge
of base rubber on drum. Sets gauge to wind specified cords per
inch around length of base rubber and starts drum revolving.
Lays one or more plies of filler rubber on top of cord.
Starts
pressure rollers that compress material on drum. Positions
notched cutting bar across front of drum and cuts belting to
specified width by holding knife in notches and pressing knife
against reovlving drum. Collapses drum and palces cut belts on
rack.
|
Write a comment about the job
V-Belt Builder
|
